v Boot Mode Menu
The Boot Mode Menu allows you to select a boot mode.
Boot Mode Menu
1. Boot to SMS Menu:
Currently Disabled
2. Service Mode Boot from Saved List:
Currently Disabled
3. Service Mode Boot from Default List:
Currently Disabled
4. Boot to Open Firmware Prompt:
Currently Disabled
98. Return to Previous Menu
1>
To select a boot mode, select a number and press Enter. The item corresponding to the selected
number toggles from disabled to enabled. If the same number is selected again, the item toggles from
enabled to disabled. If a boot mode is enabled, the boot mode selected is performed, and the
disabled/enabled selection is reset to disabled. Following is a description for each boot mode:
– Boot to SMS Menu
When this selection is enabled, the system boots to the System Management Services (SMS) menu.
– Service Mode Boot from Saved List
This selection causes the system to perform a service mode boot using the service mode boot list
saved in NVRAM. If the system boots AIX from the disk drive and AIX diagnostics are loaded on the
disk drive, AIX boots in service mode to the diagnostics menu.
Using this option to boot the system is the preferred way to run online diagnostics.
– Service Mode Boot from Default List
This selection is similar to “Service Mode Boot from Saved List”, except the system boots using the
default boot list that is stored in the system firmware. This is normally used to try to boot customer
diagnostics from the CD-ROM drive.
Using this option to boot the system is the preferred way to run standalone diagnostics.
– Boot to Open Firmware
When this selection is enabled, the system boots to the open firmware prompt.
This option should only be used by service personnel to obtain additional debug information.
Chapter 8. Using the Service Processor 371
To Next Page
Loading...
Need help?
General