Front Service Position
To place a drawer in the front service position, do the following:
Attention: Do not pull the drawer out from the front. The drawer must be pushed to the front service
position from the rear of the system.
1. If you have not already done so, open the front door of the rack unit.
2. Loosen the two thumbscrews that attach the front bezel to the drawer.
3. Grasp both sides of the front bezel and pull it off the drawer.
4. Remove the screws that attach the left and right retaining brackets and remove the brackets.
5. If you have not already done so, open the rear door of the rack unit.
6. If present, remove two screws securing the drawer to the rack. Refer to “Rear Service Position” on
page 463.
7. Push the drawer forward until it is stopped by the two detents.
464 Service Guide
To Next Page
Loading...
Need help?
General