v Read Service Processor Configuration
Displays current service processor configuration.
v Processor Configuration/Deconfiguration Menu
This menu allows the user to change the system processor configuration. If it is necessary to take one
of the processors offline, this menu allows you to deconfigure a processor, and then reconfigure the
processor at a later time. An example of this menu is shown below:
PROCESSOR CONFIGURATION/DECONFIGURATION MENU
77. Enable/Disable CPU Repeat Gard: Currently Enabled
1. 0 3.0 (00) Configured by system
2. 1 3.1 (31) Deconfigured by system
3. 2 3.2 (00) Configured by system
4. 3 3.3 (00) Configured by system
5. 4 4.0 (00) Configured by system
6. 5 4.1 (00) Configured by system
7. 6 4.2 (00) Configured by system
8. 7 4.3 (00) Configured by system
98. Return to Previous Menu
1>
Note: This table is built from vital product data collected during the last boot sequence. The first time
the system is powered up, or after the system’s non-volatile RAM (NVRAM) has been erased,
this table may be empty. The table is rebuilt during the next boot into AIX.
The fields of the previous table represent the following:
Column 1 (1.) Menu selection index.
Column 2 (0) Logical processor device number assigned by AIX. You can display these logical
device numbers by issuing the following command on the AIX command line:
lsdev -C | grep proc
Column 3 (3.0) Processor address list used by the service processor and should be ignored.
Column 4 (00) Error status of the processors.
Chapter 8. Using the Service Processor 373
To Next Page
Loading...
Need help?
General