KTM 690 Enduro R EU 2012 User Manual

16 LIGHTING SYSTEM, INSTRUMENTS 98
16.1 Combination instrument
16.1.1 Setting kilometers or miles
Info
If you change the unit, the value is retained and converted accordingly.
Making the setting according to the country.
Condition
The motorcycle is stationary.
400839-01
– Switch on the ignition by turning the ignition key to position ON .
– Press the MODE button repeatedly until the ODO mode is active.
– Keep the MODE button pressed until the display mode changes from km/h to mph or
from mph to km/h.
Guideline
Activation duration of MODE button 10 s
16.1.2 Setting the clock
Condition
The motorcycle is stationary.
400838-01
– Switch on the ignition by turning the ignition key to position ON .
– Press the MODE button repeatedly until the ODO mode is active.
– Keep the MODE button and the SET button pressed simultaneously.
The time display begins to flash.
– Press the MODE button to set the hour.
– Press the SET button to set the minute.
– Keep the MODE button and the SET button pressed simultaneously.
The time is set.
16.1.3 Setting/resetting display TRIP 1
Info
The TRIP 1 trip counter runs constantly and counts up to 999.9.
The trip counter can be used to measure the distance covered during trips or between two refueling stops. After the value
999.9 is reached, the trip counter starts at 0.0 again.
400840-01
– Switch on the ignition by turning the ignition key to position ON .
– Press the MODE button repeatedly until the TRIP 1 mode is active.
– Keep the SET button pressed.
The TRIP 1 display is set to 0.0.
16.1.4 Setting/resetting display TRIP 2
Info
The TRIP 2 trip counter runs constantly and counts up to 999.9.
The trip counter can be used to measure the distance covered during trips or between two refueling stops. After the value
999.9 is reached, the trip counter starts at 0.0 again.

KTM 690 Enduro R EU 2012 Specifications

General

Brand	KTM
Model	690 Enduro R EU 2012
Category	Motorcycle
Language	English