Kubota G2000 4WS User Manual

G1700·G1800G1900G2000 WSM,10830
S.G GENERAL
(2) Check Points of Initial SO Hours
Changing Engine Oil
A CAUTION
• Before changing
the engine oil. be sure to stop the engine.
1. Place the machine on level ground.
2. Remove the drain plug (1) at the bottom of the engine, and
drain the used oil completely.
All used oil can be drained out easily while the engine still
warm.
3. After draining the oil, reinstall the drain plug.
4. Fill with new oil up to the upper level (a) on the oil level
dipstick (3) .
• IMPORTANT
• Use
the specified engine oil.
Refer to "LUBRICANTS, FUEl AND COOLING WATER". (See
page S.G-2)
(1) DrainPlug
(a) Upper level
(2) Oil Filler Plug
(b) lower Level
(3) Oil level Dipstick
Changing Engine Oil Filter Cartridge
A CAUTION
• Before changing
the engine oil filter cartridge, be sure to
stop the engine.
1. Remove the engine oil filter cartridge (1).
2. Apply engine oil slightly to the rubber gasket of new
cartridge.
3. Install the new cartridge, screwing it in by hand.
Over-tightening may cause deformation of the rubber
gasket.
4. After the cartridge has been changed, the engine oil level
normally lowers a little. Add engi ne oil to proper level.
• IMPORTANT
• To
prevent serious damage to the engine. replacement oil
filter cartridge must be highly efficient. Use only a genuine
KUBOTA filter cartridge or its equivalent.
(1) Engine Oil Filter Cartridge
S.G-7
131

Kubota G2000 4WS Specifications

General

Brand	Kubota
Model	G2000 4WS
Category	Tractor
Language	English