13. FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK
13-19
DINK 50/125
Measure the resistance between the auto
choke wire terminals.
Resistance:
10 Ω below (10 minutes minimum after
stopping the engine)
If the reading is not within the limit, replace
the auto auto choke with a new one.
Connect a hose to the fuel enriching circuit
of the carburetor. Connect the auto choke
yellow wire to the positive (+) terminal of a
battery and green/black wire to the negative
(-) terminal. Wait 5 minutes and blow the
hose with mouth. If the passage is blocked,
the auto choke is normal.
Disconnect the auto choke from the battery.
Wait 30 minutes and blow the hose with
mouth. If air can be blown into the hose, the
auto choke is normal.
INSTALLATION
Install the auto choke and set plate.
Install and tighten the two screws.
Auto Choke/Set Plate
To Next Page
Loading...
Need help?
General
