19. LIGHTS/METERS/SWITCHES
19-15
DINK 50/125
HEATER CONTROLLER UNIT
(DINK 125 ONLY)
INSPECTION
Heater control unit inspection
1.Open ignition switch to check if the brown
/blue wire of it is enough voltage.
2.Put the heater controller unit in refrigerator.
Start engine after keeping the temperature
under 10 ± 4℃.
3.Start engine and if the temperature of heater
controller unit is under 10 ± 4℃. Check if
the white/yellow wire of heater controller
unit has output voltage. If it has not any
voltage. It is damaged.
REMOVAL/INSTALLATION
Remove the luggage box (refer to the
“FRAME COVERS
REMOVAL/INSTALLATION).
Disconnect the controller unit connector (1).
Remove the bolt (2) and heater controller
unit.
Installation is in the reverse order of removal.
To Next Page
Loading...
Need help?
General
