1. GENERAL INFORMATION
1-2
DINK 50/125
SPECIFICATIONS(DINK 50)
Overall length 2030 mm (81.2 in)
Overall width 780 mm (31.2in)
Overall height 1255 mm (50.2 in)
Wheel base 1390 mm (55.6 in)
Engine type
Air cooled 4-stroke,
OHC engine
Displacement 49.5cc (2.97 cu-in)
Fuel Used 92↑ nonleaded
gasoline
Front wheel 47 kg (103.4 lb)
Rear wheel 64 kg (140.8 lb)
Dry weight
Total 111 (244.2 lb)
Front wheel 52 kg (114.4lb)
Rear wheel 69 kg (151.8lb)
Curb weight
Total 121 kg (266.2 lb)
Front wheel 120/70-13
Tire
Rear wheel 130/70-12
Ground clearance 140 mm (308 in)
Braking distance 7 m/30 km/hr
Min. turning radius 2350 mm (94 in)
Starting system
Starting motor/Kick
starter
Type Gasoline, 4-stroke
Cylinder arrangement Single cylinder
Combustion chamber type Triple-sphere
Valve arrangement O.H.C.
Bore x stroke 39.0×41.6 mm
(1.56×1.66 in)
Compression ratio 11:1
Compression pressure
18 kgf/cm
2
(1800
kPa, 256 psi)-Max
Open 3° (BTDC)
Intake
Close 11° (ABDC)
Open -9° (BBDC)
Exhaust
Close 19° (ATDC)
Intake 0.05 mm (0.002 in)Valve
clearance
(cold)
Exhaust 0.05 mm (0.02 in)
Idle speed (rpm) 2000~2200rpm
Lubrication type
Forced pressure &
Wet sump
Oil pump type Inner/outer rotor type
Oil filter type Full-flow filtration
Oil capacity
0.85 L (0.748 lmp qt,
0.901 US qt))
Lubrication System
Oil exchanging
capacity
0.7L (0.616 lmp qt,
0.742 US qt)
ENGINE
Cooling Type Air cooling
Air cleaner type & No Paper element, wet
Fuel capacity
7 L (1.47 lmp gal,
1.82 US gal)
Type LFA1
Main jet No. #100(speed limited:#90)
Venturi dia. φ17mm (φ0.68 in)
Fuel System
Carburetor
Throttle type piston
Type CDI
Ignition timing 13°/2100 rpm
28°/4000r