13. FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK
13-34
DINK 50/125
AUTO BYSTARTER INSPECTION
Measure the resistance between the auto
by-starter wire terminals.
Resistance: 10Ω (10 minutes minimum after
stopping the engine)
If the reading is not within the limit, replace the
auto by-starter with a new one.
Connect a hose to the fuel enriching circuit of
the carburetor. Connect the auto by-starter
green/black wire to the positive (+) terminal
of a battery and black/white wire to the
negative (-) terminal. Wait 5 minutes and
blow the hose with mouth. If the passage is
blocked, the auto by-starter is normal.
Disconnect the auto by-starter from the battery.
Wait 30 minutes and blow the hose with
mouth. If air can be blown into the hose, the
auto by-starter is normal.
AUTO BYSTARTER REMOVAL
Remove the by-starter cap.
Remove the one set plate screw and set plate
and then remove the auto by-starter from the
carburetor body.
By-starter Cap By-starter Screw
Set Plate
To Next Page
Loading...
Need help?
General
