KYMCO Dink 50 User Manual

6
6-19
. CYLINDER HEAD/VALVES
DINK 50/ 125
CYLINDER HEAD COVER
REMOVAL
Remove the rear body cover.
Disconnect the crankcase breather tube from
the cylinder head cover.
Disconnect the secondary air apply hose from
the cylinder head cover.
Remove the four bolts and two nuts from the
cylinder head cover, then remove the cylinder
head cover.
INSTALLATION
Install a new cylinder head cover O-ring and
gasket.
Install the cylinder head cover.
Install and tighten the cylinder head cover
bolts and nuts.
Torque: 0.8～1.2kgf-m
CAMSHAFT/CAMSHAFT
HOLDER
REMOVAL
Remove the cylinder head cover. (Refer to
the “CYLINDER HEAD COVER
REMOVAL”)
Remove the cam chain tensioner cap/spring.
Remove two bolts and cam chain tensioner.
Cylinder Head Cove
r
Be sure to install the O-ring into the
groove properly.
＊
Bolts
O-ring
Tensioner Cap
N
u
t
s
Gaske
t
Bolts

KYMCO Dink 50 Specifications

General

Brand	KYMCO
Model	Dink 50
Category	Scooter
Language	English