19. LIGHTS/METERS/SWITCHES
19-1
DINK 50/125
SERVICE INFORMATION
GENERAL
• Note the following when replacing the halogen headlight bulb
ä Wear clean gloves while replacing the bulb. Do not put finger prints on the headlight bulb,
as they may create hot spots on the bulb and cause it to fail.
ä If you touch the bulb with your bare hands, clean it with a cloth moistened with alcohol to
prevent its early failure.
ä Be sure to install the dust cover after replacing the bulb.
• Check the battery condition before performing any inspection that requires proper battery
voltage.
• A continuity test can be made with the switches installed on the scooter.
• Route the wires and cables properly after servicing each component.
A halogen head light bulb becomes very hot while the head light is on, and remains for a while
after it is turned off. Be sure to let it cool down before servicing.
＊
To Next Page
Loading...
Need help?
General
