3. INSPECTION/ADJUSTMENT
3-10
DINK50/125
5. Install the new oil filter.
6. Install the spring, O-ring and cap.
Cap bolt torque:
12 N-m (1.2 kgf-m, 8.6 lbf-ft)
7. Fill the crankcase with the recommended
grade oil and install the oil filler cap.
Oil capacity (after draining):
0.9 liter (0.95 US qt, 0.8 lmp qt)
8. Start the engine and let it idle for 2－3
minutes.
9. Stop the engine and check that the oil level
is at the upper level mark on the oil filler
cap/dipstick with the scooter upright on
firm, level ground. Make sure there are no
oil leaks.
Make sure the rubber seal on the oil filte
To Next Page
Loading...
Need help?
General
