5-66 Image Optimization
small. As the level increases, the rendered image will become warmer but the details remain the same.
Also, the shadow border will be smoother while the shadow area will be large
Light source adjustment
This function adjusts the position of the light source toward the VR image.
Select the direction by touching the buttons under the “Light Position” box.
You can also make fine adjustments by tapping [Move Light] and rolling the trackball to adjust.
Grad View
After this function is activated, VR details will be revealed and enhanced.
Other operation controls and adjusting methods are similar to those in 3D/4D mode.
Lighting Mode
Basic Procedures
1. Tap “
” on the [iLive] to enter the iLive settings interface.
2. Tap the desired lighting mode.
a) If necessary, tap “
” on the lighting mode to adjust parameters for the selected lighting mode.
b) After parameter settings, tap [Exit XXX] to exit the lighting mode settings.
c) Tap [Refresh] to refresh the thumbnails on the iLive settings interface.
3. Tap [Return] to apply the selected lighting mode.
Operation Controls for Lighting Mode Settings
Parameter Description
VL Saturation Adjust the saturation for light 1/2/3.
VL Hue Adjust the color for light 1/2/3.
VL Distance
Adjust the distance for light 1/2/3 when the light source is set to
torch or point.
The larger the distance, the more the illuminated part on the
surrounding area of the image; vice versa.
VL Angle
Adjust the angle for light 1/2/3 when the light source is set to
torch.
The larger the angle, the larger the scope of light beam, and the
larger the illuminated area; vice versa.
At the front
On the left
On the right
At the back
At the
bottom left
At the top right
To Next Page
Loading...
Need help?
General
