iWorks (Auto Workflow Protocol) C-5
C.5 View Operation
In iWorks status, you can perform view selection, repeat, replacement and delete operations using the
touch screen.
For some views, the system switches to the relevant imaging modes if necessary.
The comment for the current view has been automatically added to the bottom-left corner of the image,
ready for you to scan the specified anatomy.
C.5.1 View Selection
Touch [Prev]/[Next] to select the view to be scanned. The current view is surrounded by a solid green
frame.
C.5.2 View Operation
In the current active view, you can perform image scanning, measurements, and adding comments and
body marks, etc. Operations are the same as those for manual operation. See the relevant chapters for
details.
C.5.3 Repeat View
If necessary, touch [Repeat] to insert another template of the current view. You can then perform an
extra examination.
C.5.4 View Replacement
The previous image will be deleted and replaced by the new image.
C.5.5 Delete View
Touch [Prev]/[Next] to select the view to be deleted. Touch [Delete] to delete the selected view.
To Next Page
Loading...
Need help?
General
