11
MAINTENANCE AND INSPECTION
11 - 1
9
EMC AND LOW
VOLTAGE
DIRECTIVES
10
LOADING AND
INSTALLATION
11
MAINTENANCE AND
INSPECTION
12
TROUBLESHOOTING APPENDICES INDEX
CHAPTER11 MAINTENANCE AND INSPECTION
DANGER
Do not touch the terminals while power is on.
Doing so could cause shock.
Correctly connect the battery. Also, do not charge, disassemble,
heat, place in fire, short circuit, or solder the battery.
Mishandling of a battery can cause overheating or cracks which
could result in injury and fires.
Switch off all phases of the externally supplied power used in the
system when cleaning the module or retightening the terminal or
module mounting screws.
Conducting these operations when the power is on could result in
electric shock.
Loose terminal screws may cause short circuits or malfunctions.
Failure to mount the module properly will result in short circuit,
malfunction or in the module falling.
To Next Page
Loading...
Need help?
General
