Electrical System 138Service Manual – CS7000
8. Remove the tank guard plate.
a. Remove plate to frame bolts.
b. Remove the plate to belt guard bolts.
c. Remove the “P” clamp cable and fuel line fasteners.
9. Remove the belt tension release tool from the side of the starting battery.
Remove Bolts
Tool
10. Using the bolts that had attached the tool to the battery tray, bolt one end of the tool to the tensioner
pulley and bolt the other end to the generator pulley. Pull the two tool halves together by “tightening”
the long bolt. This will compress the auto-tensioner “spring” and release the tension on the drive belt.
Turn the bolt until there is enough slack to remove the belt.
Install Bolts
Tool
Tighten Bolt
11. Remove the belt.
12. Reassemble in reverse order.
Tank Guard
Plate
Belt Guard
Bolts
To Next Page
Loading...
Need help?
General
