Electrical System 139Service Manual – CS7000
42 volt Generator
1. Remove Engine and Generator as an assembly. See relevant engine chapter.
2. Remove generator drive belt.
3. Label wiring for correct reassembly and then remove.
4. Support generator with a lift.
5. Remove generator to engine mounting bolts
Rear
Mounting
Bolt
Front
Mounting
Bolts
6. Remove generator.
7. Reassemble in reverse order.
Generator Drive Belt Tensioner
1. Remove Drive Belt.
2. Retract the tensioner tool bolt to relieve the spring tension.
3. Remove the tensioner tool.
4. Raise and lock hopper in place.
5. Remove lower rubber curtain fasteners to gain access to engine area and move the curtain aside.
6. Remove the tensioner mounting bolt from the back side of the generator mounting bracket. See photo.
In Here
7. Reassemble in reverse order.
To Next Page
Loading...
Need help?
General
