Nilfisk-Advance CS7000 Service Manual

Sweep System, Side Broom 404Service Manual – CS7000
To Remove and Reinstall a Side Broom Hub Assembly
1. Remove the side broom motor assembly from the machine.
2. Make sure the Motor Assembly and Side Broom
Hub Assembly
are adequately supported, then
carefully drive out the Spring Pin.
3. Remove the Side Broom Hub Assembly from
the Gearbox Shaft.
4. Reinstall the Side Broom Hub Assembly by
following the above steps in reverse order.
Service Note: Coat the Gearbox Shaft
with Never-Seez
®
or equivalent anti-seize
compound before installing the Side
Broom Hub Assembly
.
To Remove and Reinstall the Side Broom Actuator
1. Dump the hopper.
2. Make sure the parking brake is engaged.
3. Turn the key switch on and switch the machine to the Service Mode.
4. Raise the hopper far enough to minimize the weight of the side brooms on the actuator, then support the
hopper with jack stands or other suitable supports.
Warning! Always make sure the hopper is adequately supported before performing any work
on or underneath the hopper.
5. Cut the wire tie and disconnect the side broom actuator electrical connector.
Side Broom Hub
Assembly
Spring Pin
Gearbox
Shaft
Motor
Assembly

Nilfisk-Advance CS7000 Specifications

General

Brand	Nilfisk-Advance
Model	CS7000
Category	Floor Machine
Language	English