Nilfisk-Advance CS7000 Service Manual

Scrub System 306Service Manual – CS7000
Maintenance and Adjustments
Warning! Before performing any machine maintenance or adjustments, make sure the key
switch is off, the key is removed from the machine and the parking brake is engaged.
To Replace a Leading Deck Blade
1. Loosen the Knob and
swing out the edge
guard (not shown -
on right-hand side
squeegee assembly
only).
2. Remove the two Wing
Knobs
.
3. Remove the Strap
Weldment
and Leading
Deck Blade
from inside
of the Blade Support
Weldment
.
4. Reverse the existing
Trailing Deck Blade to
position a new blade
surface on the oor, or
install a new Trailing
Deck Blade
onto the
Strap Weldment pins as
shown.
5. Install the Trailing Deck Blade and Strap Weldment on the inside of the Blade Support Weldment, then
reinstall and tighten the two Wing Knobs.
6. Swing the edge guard back into position, then tighten the Knob (right-hand side squeegee assembly
only).
To Replace a Trailing Deck Blade
1. Loosen the Knob and swing out the edge guard (not shown - on right-hand side squeegee assembly only).
2. Press the Latch Lock, open the Latch and remove the Blade Strap and Trailing Deck Blade from the Blade
Support Weldment
.
3. Reverse the existing Trailing Deck Blade to position a new blade surface on the oor, or install a new
Trailing Deck Blade onto the Blade Support Weldment pins as shown.
4. Hook the end of the Blade Strap into the matching Tab on the Blade Support Weldment.
5. Wrap the Blade Strap over the Trailing Deck Blade and close the Latch.
Latch
Latch
Lock
Blade Strap
Wing
Knob (2)
Leading Deck
Blade
Strap
Weldment
Blade
Support
Weldment
Knob
Trailing Deck
Blade
Tab

Nilfisk-Advance CS7000 Specifications

General

Brand	Nilfisk-Advance
Model	CS7000
Category	Floor Machine
Language	English