Nilfisk-Advance CS7000 Service Manual

Squeegee System 347Service Manual – CS7000
To Remove and Reinstall the Rear Squeegee Blade
1. Release the Latch and remove
the Squeegee Strap.
2. Remove the Rear Squeegee
Blade
from the Squeegee
Weldment
.
3. Rotate the existing Rear
Squeegee Blade
top-to-bottom
or end-for-end to position a
new blade surface on the oor,
or install a new Rear Squeegee
Blade
onto the Squeegee
Weldment
pins.
4. Reinstall the Squeegee Strap,
then close the Latch.
Squeegee End Wheels
Once a month apply light machine oil to the Squeegee End Wheels.
Squeegee Caster Wheel Bearings
Once a month pump a small amount of grease into the Grease Fitting on
both caster wheels on the squeegee support assembly until grease seeps
out around the bearings.
Latch
Squeegee
Weldment
Squeegee
Strap
Rear
Squeegee
Blade
Squeegee End
Wheel (2)
Grease
Fitting

Nilfisk-Advance CS7000 Specifications

General

Brand	Nilfisk-Advance
Model	CS7000
Category	Floor Machine
Language	English