Engine System - LPG 176Service Manual – CS7000
Troubleshooting
Checking Spark
1. Remove the spark plug wire from the spark plug
and insert an adjustable KV tester in the end of
the wire.
2. Adjust the gap to approximately 20 - 30 KV and
clip the tester to a good ground on the engine.
3. Crank the engine over and check for consistent
arcing across the tester gap.
Checking LPG Primary Pressure
1. Turn off the propane tank valve with the engine
running and allow the engine to run out of fuel.
2. Turn key switch off.
3. Remove the primary chamber test port plug
located on top of the vaporizer regulator.
4. Install thread adapter part number 50360A into
the test port.
5. Install tting from LPG pressure test kit into
the thread adapter.
Test Port Plug -
1/8” BPST
To Next Page
Loading...
Need help?
General
