Poly Studio X30 Administrator's Guide

You must have a DHCP server deployed in your environment.
WARNING! If your network environment only supports IPv6, you must manually configure a static
IPv4 address. For example, manually configure the IPv4 IP address to 192.168.0.4.
1. In the system web interface, go to Network > LAN Network > IP Addresses.
2. Select the Enable IPV6 checkbox.
3. For IP Address, select Obtain IP address automatically.
4. Select the Enable SLAAC checkbox to enable the system to use stateless address
autoconfiguration (SLAAC) to automatically obtain IP address.
Manually Configure IPv6 Address Settings
You can manually configure the system’s IPv6 address settings.
WARNING! If your network environment only supports IPv6, you must manually configure a static
IPv4 address. For example, manually configure the IPv4 IP address to 192.168.0.4.
1. In the system web interface, go to Network > LAN Network > IP Addresses.
2. Select the Enable IPV6 checkbox.
3. For IP Address, select Enter IP address manually.
4. Configure the following settings:
Setting
Description
Link-Local Specifies the IPv6 address to use for local communication
within the subnet.
Site-Local Specifies the IPv6 address to use for communication
within the site or organization.
Global Address Specifies the IPv6 internet address.
Default Gateway Specifies the default gateway assigned to your system.
5. Select Save.
Manually Assign a Host Name and Domain Name
You can manually enter the host name and domain name for your system. You also can modify these
settings even if your network automatically assigns them.
1. In the system web interface, go to Network > LAN Network > LAN Options.
2. Enter or modify the system Host Name.
Indicates your system name. If the system discovers a valid name during setup or a software
update, the system automatically creates the host name. However, if an invalid name is found,
such as a name with a space, the system creates a host name using the following format: Syste
mType-xxxxxx, where xxxxxx is a set of random alphanumeric characters.
IPv4 networks: The system sends the host name to the DHCP server to attempt to register
the name with the local DNS server or look up the domain where the system is registered (if
supported).
48
Chapter 6Configuring Network Settings

Poly Studio X30 Specifications

General

Brand	Poly
Model	Studio X30
Category	Conference System
Language	English