Configuring Audio Settings8
You can configure audio settings in the system web interface.
Configure General Audio Settings
You can specify general audio settings for your system.
If you are in a call with a far site that is sending audio in stereo mode, you can receive in stereo. In
calls where some sites can send and receive stereo but some can’t, any site set up to send or receive
stereo can do so.
NOTE: Some audio settings are unavailable when you connect a SoundStructure digital mixer to
your system.
1. In the system web interface, go to Audio/Video > Audio > General Audio Settings.
2. Configure the following settings (your changes save automatically):
Setting
Description
Polycom StereoSurround Enables Polycom StereoSurround software for all calls.
NOTE: Enabling this setting disables Polycom Acoustic
Fence technology and vice versa.
This feature isn’t available on the Studio X30 system.
It also isn’t available when using a Poly Microphone IP
Adapter or Poly Trio microphones with your system.
Sound Effects Volume Sets the volume level of the ringtone.
Ringtone Specifies the ringtone for incoming calls.
Enable M-Mode Specifies whether the system transmits audio using a
configuration that best reproduces interactive and live
performance music picked up by microphones. This
feature provides the highest-possible bandwidth for audio.
When you enable M-Mode, even the faintest musical
notes come through clearly.
Enable NoiseBlockAI
Enables Poly NoiseBlockAI, which during a call eliminates
background and extraneous sounds in common working
environments.
NOTE: This setting is disabled when you enable M-
Mode. If you use an external echo canceller, keyboard
noise reduction isn’t available.
Enable Join and Leave Tones
The system plays a tone when someone joins or leaves a
conference call.
Configuring Audio Settings 73
To Next Page
Loading...
Need help?
General
