Poly Studio X30 Administrator's Guide

Install the PKI certificates on your system required for authenticating with your network.
NOTE: 802.1X isn’t supported in IPv6 environments.
The system supports the following authentication protocols:
● EAP-MD5
● EAP-TLS
● EAP-TTLS
– EAP-MSCHAPv2
– EAP-GTC
● EAP-PEAPv0 (MSCHAPv2)
– EAP-MSCHAPv2
– EAP-GTC
1. In the system web interface, go to Network > LAN Network > LAN Options.
2. Select the Enable EAP/802.1X check box.
3. Select an EAP/802.1X authentication method.
4. For EAP-TTLS or EAP-PEAPv0, choose an EAP/802.1X Phase 2 Authentication.
5. Enter an EAP/802.1X Identity for your system.
You can’t leave this field blank.
6. Enter an EAP/802.1X Password for your system.
This setting is required when you use EAP-MD5, EAP-PEAPv0, or EAP-TTLS.
7. Select Save.
Configure Wired LAN Options
You can configure other LAN properties for your G7500 and Studio X series system in the local
interface or the system web interface.
1. In the system web interface, go to Network > LAN Network > LAN Options.
2. Configure the following settings:
Setting
Description
Autonegotiation
(under General Settings in the local interface)
Specifies whether the system should automatically
negotiate the LAN speed and duplex mode per IEEE
802.3 autonegotiation procedures. If you enable this
setting, the system sets
LAN Speed and Duplex Mode
to read-only.
Poly recommends that you use autonegotiation to avoid
network issues.
50 Chapter 6Configuring Network Settings

Poly Studio X30 Specifications

General

Brand	Poly
Model	Studio X30
Category	Conference System
Language	English