Standard Features M101 M102 M103
Output Tray (10 sheets) Yes Yes Yes
Paper Tray (50 sheets) Yes Yes Yes
Platen (book mode scanning) No Yes Yes
The following features are not supported by these machines:
• Bulk paper feed unit (only one small tray is available)
•
USB2 Print, Scan2 USB
• Handset for fax with M103
• Wireless LAN option
• NRS support (no UZ, Basil, or Cumin options available)
• Memory expansion
• HDD expansion
• G3 expansion (no G3 option available for M103)
• PictBridge
Duplex Printing
These machines have no mechanism for automatic duplexing.
• However, the operator can run a print job and print on the first side of the pages, remove the
printed sheets from the output tray, turn the stack over so the blank side is facing up, load the stack
in the paper feed tray, and then run another job to print on the second sides of the pages.
•
Both portrait and landscape printing are possible. Duplex printing must be set up with the print
application. For more details, refer to the operating instructions.
Important Points to Remember
These are very important points to keep in mind while using the service manual:
• Functionality. Only the M103 has both the ADF and flatbed unit. The M102 has the flatbed unit but
not the ADF. The M101 has neither ADF nor flatbed.
• Smart Organizing Monitor. This utility (installed with the printer driver at installation) is used to
configure the system and handle errors of all three machines of this series.
• Message and error displays. Only the M103 has a 7-digit display that can show errors (SC codes)
and messages. The M102 display is limited to two digits, and the M101 has no display. The
Service Mode of Smart Organizing Monitor can be used to view error messages for all three
machines.
1. Product Information
24
To Next Page
Loading...
Need help?
General