• Printing reports and test pages
The Smart Organizing Monitor is provided with the machine on a CD-ROM and must be installed
together with the printer driver.
Important Features
Here are some important features you should remember:
• The AIO units for these machines have no ID chips attached to the AIO units.
•
The toner supply is monitored using a dot count for the M103 only.
• The AIO units of these machines can be refilled by a trained service technician up to three times,
depending on usage. This extends the service life of the AIO unit.
• Before loading paper, the paper size and paper type must be selected on the initial screen (System
Settings) of the smart Organizing Monitor. The same paper size and paper type must also be
selected with the printer driver at the start of a job. A mismatch error will occur if the paper size/
type settings in the Smart Organizing Monitor and the printer driver are not the same.
• The accessory AIO (capacity: 500 prints) provided with the machine should be installed in the
machine at installation. After the accessory AIO runs out of toner, it can be replaced with a new
AIO (capacity: 2000 prints). This is especially important for the M103.
2. Installation
38
To Next Page
Loading...
Need help?
General