4. Do not put the machine in areas with sudden temperature changes. This includes:
• Areas directly exposed to cool air from air conditioning
•
Areas directly exposed to heat from a heating system.
5. Do not put the machine in areas exposed to corrosive gas.
6. Do not install the machine at locations over 2,000 m (6,562 ft.) above sea level.
7. Put the machine on a strong, level base. (Tilting towards any side must be no more than 3 mm.)
8. Do not put the machine in areas with strong vibrations.
Power Requirement
Power Source:
220 to 240V 50/60 Hz 4A or less (Asia/ EU)
120V 60 Hz 6A or less (NA)
Check the machine installation and confirm the following important points:
• Power plug fits tightly in the outlet.
•
Power plug is clean and free of dust.
• The machine power plug is not connected to a shared source.
• The machine should be properly grounded.
• The power cord should be free and not wrapped around the leg of a chair or table, or bundled.
Machine Level
Make sure that the machine is located on a flat surface.
Front to back Within 5 mm (0.2") of level
Right to left Within 5 mm (0.2") of level
Space Requirements
The machine should be used in a location that meets these minimum space requirements.
2. Installation
36
To Next Page
Loading...
Need help?
General