• Before you disconnect the ink tubes, squeeze their connecting parts[ A] with fingers or radio
pliers to empty their contents into the print head tanks, so as to prevent the ink from dropping.
•
If air enters the print head tanks, it will cause the ink to spill out of the print head nozzles.
Therefore, to ensure that ink does not spill, take measures such as blocking the openings for
the tubes or putting the carriage into a plastic bag.
10. Re-assemble the printer.
• Before you re-assemble the printer, be sure to read through the "Re-installation" tips described
in the next section.
11.
After re-assembling the printer, do the SP settings for after carriage replacement. (See "After
Replacing the Carriage" at the end of this section.)
Re-installation
Lock the Carriage
Make sure the carriage is locked before re-attaching the machine covers.
1. Turn the screwdriver [A] counter-clockwise to rotate the triangle.
2.
Stop rotating when the triangle is at the lock position [B].
• Never rotate the screwdriver clockwise.
FFC Installation
To prevent the FFC from arching too much, store part of it in the holder.
Carriage Unit
133
To Next Page
Loading...
Need help?
General