Head Position
The print head is out of position if you see these:
•
Broken vertical lines
• Blurred, smeared or streaked colors
Do the following procedure to correct these problems.
1. [
/Menu]> "Counter"
2.
[
/Menu] or [ ]> "Maintenance"> [#Enter]> "Nozzle Check".
3.
[
/Menu] or [ ]> "Head Position"> [#Enter]> "Select "Pr. Test Pattern"
4.
[#Enter]> [
/Menu] or [ ]> "High Speed", "Standard", "High Quality", or "Envelope Print">
[#Enter]. The test pattern prints.
• Do not start any other operation until printing stops.
• J035 can select only either “High speed” or “Standard” in the print test pattern menu.
5. Look at the patterns and determine which is the best.
• The best pattern is the gray square with straight vertical lines on both sides.
• The pattern setting is read as a matrix value from the pattern. For example, if the best pattern is
in column "+2", line "A", the entry for adjustment will be "A" then "+2"
6. [ /Menu]> "Adjustment"> [#Enter].
7.
[
/Menu] or [ ]> Select same setting selected for "Pr. Test Pattern" in Step 4 ("High Speed",
"Standard", "High Quality", or "Envelope Print")> [#Enter].
• J035 can select only either “High speed” or “Standard” in the print test pattern menu.
Print Head Cleaning and Adjustment
143
To Next Page
Loading...
Need help?
General