Ricoh BRG-P1 User Manual

360 pages

To Next Page

To Previous Page

• For replacement parts use only the correct fuses, thermistors, circuit breakers, etc. rated for use with

the machine. Using replacement devices not designed for use with the machine could cause a fire

and personal injuries.

Organic Cleaners

• During cleaning never use any organic cleaners (alcohol, etc.) other than those described in the

service manual.

•

Make sure the room is well ventilated before using any organic cleaner. Always use organic

solvents in small amounts to avoid breathing the fumes and becoming nauseous.

• Switch the machine off, unplug it, and allow it to cool before doing preventive maintenance.

• To avoid fire or explosion, never use an organic cleaner near any component that generates heat.

• Wash your hands thoroughly after cleaning parts with an organic cleaner to avoid contamination

of food, drinks, etc.

Power Plug and Power Cord

• Before servicing the machine (especially when responding to a service call), always make sure that

the power plug has been inserted completely into the power source. A partially inserted plug could

generate heat (due to a power surge caused by high resistance) and cause a fire or other

problems.

•

Always check the power plug and make sure that it is free of dust and lint. Clean it if necessary. A

dirty plug can generate heat and cause a fire.

• Inspect the entire length of the power cord for cuts or other damage. Replace the power cord if

necessary. A frayed or otherwise damaged power cord can cause a short circuit which could lead

to a fire or personal injury from electrical shock.

• Check the length of the power cord between the machine and power supply. Make sure the power

cord is not coiled or wrapped around any object such as a table leg. Coiling the power cord can

cause excessive heat to build up and could cause a fire.

• Make sure that the area around the power source is free of obstacles so the power cord can be

removed quickly in case of an emergency.

• Make sure that the power cord is grounded (earthed) at the power source with the ground wire on

the plug.

• Connect the power cord directly into the power source. Never use an extension cord.

• When you disconnect the power plug from the power source, always pull the plug, not the cable.

Questions and Answers: