2. The CTL Board (All s, all s, x 6).
After Replacement
After replacing the CTL board, you need to specify the serial number, PnP code, and destination, and
then initialize the NVRAM. Be sure to perform this in the order of (1) specifying the serial number, (2)
specifying the PnP code and destination, and (3) initializing the NVRAM.
(1) Serial number
1.
Switch the machine on.
2. Enter the SP mode.
3. Select "Service Menu">"Serial No. Edit."> [#Enter].
00000000000
_
4. Enter the machine serial number.
•
Press [
] or [ /Menu] to move the cursor horizontally, press [#Enter] to select the digit you
want to change (among 11 digits), press [ ] or [ /Menu] to change the character, and then
and then press [#Enter] to confirm the entry. The confirmed entry appears on the upper row of
the display.
5.
After completing the entry, press [Escape].
6. Exit the SP mode.
(2) PnP code, Destination
1. Enter the SP mode.
2. Select "Engine Maint."> [#Enter].
SP No.
5907001
Boards
83
To Next Page
Loading...
Need help?
General