Ricoh IM C4510 User Manual

Basic Scanning
187
6
Basic Procedure for Performing Send to Folder
1. Press [Scanner] on the Home screen.
2. Select [To Folder] on the scanner screen.
3. Place the original on the scanner.
See "Placing an Original to Scan", User Guide (HTML).
4. Press [Send Settings] and configure the scan settings according to the purpose of
the scanned data.
page188”Scanning an Original with Suitable Quality and Density”
page192”Specifying the File Type or File Name When Scanning a Document”
5. Press , select [Search Address Book] or [Specify by Reg. No.] and then specify
the shared folder that is registered in the address book.
• To enter the information manually, press , and select [Manual Entry]. Select
SMB as the protocol and enter the required information. Press [Connection
Test] to test the connection. Press [Cancel] to abort the connection test, such as
when you make a mistake specifying Path.

Ricoh IM C4510 Specifications

General

Category	All in One Printer
Print Speed	45 ppm
Print Resolution	1200 x 1200 dpi
Copy Speed	45 cpm
Copy Resolution	600 x 600 dpi
Standard Functions	Print, Copy, Scan, Fax
Warm-up Time	21 seconds
Hard Disk Drive	320 GB
Monthly Duty Cycle	150, 000 pages
Type	Laser
Scan Resolution	600 dpi
Fax Resolution	200 x 200 dpi
Paper Capacity	Standard: 1, 200 sheets; Maximum: 4, 700 sheets
Duplex Printing	Yes
Network Connectivity	Ethernet, Wi-Fi, USB
Memory	2 GB RAM
Control Panel	10.1" Smart Operation Panel
Operating System Compatibility	Windows, Mac, Linux