To Next Page

To Previous Page

18.3 I2C Decoding

I2C serial bus consists of the clock line (SCL) and the data line (SDA).

SCL: samples SDA on the rising or falling edge of the clock.

SDA: indicates the data channel.

SCL

SDA

Figure 18.7 I2C Serial Bus

In the Decode menu, click or tap the drop-down button of Bus Type to select I2C,

then configure the parameters for I2C decoding.

Figure 18.8 I2C Decoding Menu

Bus Status

Click or tap the Bus Status on/off switch to enable or disable the bus decoding.

Quickly Apply Trigger Settings to Decoding

Copy trig indicates applying the trigger settings to the specified decoding setting.

Click or tap

Copy Trig to apply the trigger settings to the specified decoding setting.

18.3.1 Source Setting

Set the clock channel source and the threshold

• Click or tap the drop-down button of CLK to select the desired source of the

clock channel. Available sources include analog channels CH1-CH4 or digital

Protocol Decoding

DHO900 User Guide

204

Rigol DHO924 User Manual

Other manuals for Rigol DHO924