Rigol DS1000Z Series User Manual

Chapter 6 To Make Measurements RIGOL
DS1000Z User’s Guide
6-27
All Measurement
All measurement could measure all the time and voltage parameters (each
measurement source has 20 items, measurements can be performed on CH1, CH2,
CH3 and CH4 at the same time) of the current measurement source and display the
results on the screen. Press Measure  Measure All to enable or disable the all
measurement function. Press All Measure Source and use to select the
channel(s) to be measured (CH1-CH4).
 When all measurement is enabled, “One-key” measurement is also valid.
 “
To Clear the Measurement” will not clear the results of all measurement.
One-key
Measurement
All Measurement

Rigol DS1000Z Series Specifications

General

Brand	Rigol
Model	DS1000Z Series
Category	Test Equipment
Language	English