Rigol DS6104 User Manual

5 To Trigger the Oscilloscope RIGOL
DS6000 User’s Guide 5-1
5 To Trigger the Oscilloscope
For trigger, you set certain trigger condition according to the requirement and when
a waveform in the waveform stream meets this condition, the oscilloscope captures
this waveform as well as the neighbouring part and displays them on the screen.
When the oscilloscope is working, it continuously acquires waveform data even if a
valid trigger does not occur. However, only when valid triggers occur, can the display
become stable. The trigger circuit guarantees that each sweep or sample starts when
the input signal meets the user-defined trigger condition, namely each sweep and
sample are synchronous and the waveforms acquired overlap to display stable
waveform.
Trigger setting should be based on the features of the input signal, thus you need to
have some knowledge of the signal under test to quickly capture the desired
waveform. This oscilloscope provides abundant advanced trigger functions which
help you to focus on the waveform details of interest.
The contents of this chapter:
 Trigger Source
 Trigger Mode
 Trigger Coupling
 Trigger Holdoff
 Trigger Type
 Trigger Output Connector

Rigol DS6104 Specifications

General

Bandwidth	1 GHz
Channels	4
Vertical Resolution	8 bits
Input Coupling	AC, DC, GND
Max Input Voltage	400 V (DC + AC peak)
Timebase Range	1 ns/div to 1000 s/div
Memory Depth	140 Mpts
Input Impedance	1 MΩ ± 1%
Trigger Types	Edge, Pulse, Video, Runt, Window
Display	10.1 inch TFT LCD
Interface	USB Host, USB Device, LAN, HDMI
Power Supply	100 V - 240 V AC, 50/60 Hz
Vertical Sensitivity	10 V/div