1 Quick Start RIGOL
DS6000 User’s Guide 1-19
Front Panel Function Overview
VERTICAL
CH1, CH2, CH3, CH4: analog input
channels. The four channels are marked
by different colors which are also used to
mark both the waveforms on the screen
and the channel input connectors. Press
any key to turn on the corresponding
channel and channel menu; press again
to turn off the channel.
AC: illuminated when the channel
coupling mode is set to AC.
50: illuminated when the channel input
impedance is 50 Ω.
BW: illuminated when the bandwidth
limit is turned on.
ALL OFF: press this key to turn off all
the channels that have been turned on.
MATH: press this key to turn on the math operation and decoding function menus
under which to perform add, subtract, multiply, divide, FFT, logic and advanced
operations as well as parallel decoding, RS232 decoding, SPI decoding, I2C
decoding, CAN decoding and FlexRay decoding.
REF: press this key to turn on the reference waveform function to compare the
waveform actually tested with the reference waveform to decide circuit failures.
VERTICAL POSITION: modify the vertical position of the current channel
waveform. Turn clockwise to increase the position and turn counterclockwise to
decrease the position. During the modification, the waveform would move up and
down and the vertical position message (e.g.
) at the lower-left
To Next Page
Loading...
Need help?
General
