Rigol DS6104 User Manual

RIGOL 6 To Make Measurements
6-24 DS6000 User’s Guide
Measurement Setting
1. Source Selection
Press MEAS  Source to select the desired channel for measurement
(CH1-CH4 or MATH). The color of the parameter icon under MENU at the left of
the screen will change with the source selected.
2. Measurement Range
Press MEAS  Range  Range to select "Screen" or "Cursor" for
measurement. When "Cursor" is selected, two cursor lines appear on the screen.
At this point, press Cursor A and Cursor B and use to adjust the positions
of the two cursor lines respectively so as to determine the measurement range.
Or, press CursorAB and use to adjust the positions of cursor A and cursor B
at the same time. Note: You can press
continuously to switch among the
cursors.
3. Delayed Measurement Setting
Specify the source A and source B in the measurement items "Delay A
→B ",
"Delay A
→B ", "Delay A →B " and "Delay A →B ".
Press MEAS  Setting  Type  "Delay" and then press Source A and
Source B to set the two channel sources (CH1-CH4) of the delayed
measurement respectively.

Rigol DS6104 Specifications

General

Brand	Rigol
Model	DS6104
Category	Test Equipment
Language	English