Rigol DS6104 User Manual

6 To Make Measurements RIGOL
DS6000 User’s Guide 6-31
Manual Mode
In this mode, you can adjust the cursors manually to measure the X (or Y) values,
the X increment (or Y increment) between the cursors and the reciprocal of the X
increment of the waveform of the specified source (CH1-CH4 or MATH). The X
cursors are a pair of vertical dotted lines and are usually used to measure the time
parameters. The Y cursors are a pair of horizontal dotted lines and are usually used
to measure the voltage parameters.
Press CURS  Mode  "Manual" to turn the manual mode on or press CURS
continuously to switch to "Manual"; the measurement results will be displayed at the
upper-left corner of the screen in the following mode.
 The X value at cursor A (A->X): take the trigger position as reference.
 The X value at cursor B (B->X): take the trigger position as reference.
 The Y value at cursor A (A->Y): take the channel ground as reference.
 The Y value at cursor B (B->Y): take the channel ground as reference.
 The horizontal difference between cursors A and B (△X).
 The reciprocal of the horizontal difference between cursors A and B (1/△X).
 The vertical difference between cursors A and B (△Y).
If needed, please refer to the following steps to modify the parameters of manual
cursor measurement.
1. Select the display mode
Press DisplayMode to select "X", "Y" or "X-Y".
 X: only display the X cursors (a pair of vertical solid/dotted lines).
 Y: only display the Y cursors (a pair of horizontal solid/dotted lines).
 X-Y: display the x cursors (a pair of vertical solid/dotted lines) and Y cursors

Rigol DS6104 Specifications

General

Brand	Rigol
Model	DS6104
Category	Test Equipment
Language	English