Rigol DS6104 User Manual

RIGOL 6 To Make Measurements
6-2 DS6000 User’s Guide
Math Operation
DS6000 can realize various math operations of waveforms between channels
including addition (A+B), subtraction (A-B), multiplication (AxB), division (A÷B), FFT,
logic operation and advanced operation. The results of math operation also allows
further measurement (for details, please refer to "Cursor Measurement").
Press MATH (in the vertical control area (VERTICAL) on the front panel)  Operate
to select the desired operation function. The result of the math operation is displayed
on the waveform marked with "M" on the screen.
Addition
Add the waveform voltage values of signal source A and B point by point and display
the results.
Press MATH  Operate to select "A+B":
 Press Source A and Source B to select the desired channels. The channels
available are CH1, CH2, CH3 and CH4.
 Press Invert to turn the invert display of the operation results on or off.
 VERTICAL POSITION, VERTICAL SCALE, HORIZONTAL
POSITION and HORIZONTAL SCALE can also be used to adjust the
display of the operation results.
 Press Label to turn on the label modifying interface. You can refer to the
introduction in "
Channel Label" to set the label of the math operation
waveform. Note: The new label can include uppercase English letters (A to Z),
lowercase English letters (a to z), numbers (0 to 9), underlines and spaces and
MATH

Rigol DS6104 Specifications

General

Brand	Rigol
Model	DS6104
Category	Test Equipment
Language	English