Rigol DS6104 User Manual

14 Remote Control RIGOL
DS6000 User’s Guide 14-1
14 Remote Control
The oscilloscope can be controlled remotely mainly using the following two methods:
User-defined programming
Users can program and control the oscilloscope by using the SCPI (Standard
Commands for Programmable Instruments) commands. For more information about
the commands and programming, refer to the
DS6000 Programming Guide .
Use PC software
Users can use the PC software to send commands to remotely control the
oscilloscope. Ultra Sigma of RIGOL is recommended. You can acquire Ultra Sigma
from the resource CD in the standard accessories or download the latest version from
RIGOL official website (
www.rigol.com).
This oscilloscope can communicate with the PC through USB, LAN or GPIB (together
with the USB to GPIB interface converter of RIGOL) instrument bus. This chapter
provides a detailed introduction of how to use Ultra Sigma to control DS6000
remotely through various interfaces.
The contents of this chapter:
 Remote Control via USB
 Remote Control via LAN
 Remote Control via GPIB

Rigol DS6104 Specifications

General

Brand	Rigol
Model	DS6104
Category	Test Equipment
Language	English