Rigol DS6104 User Manual

13 System Function Setting RIGOL
DS6000 User’s Guide 13-11
Power Status
Users can set the power status of the oscilloscope after power-on. Connect the
oscilloscope to the AC source using the power cord and turn on the power switch on
the rear panel, the oscilloscope is powered on.
Press UTIL  PowerStatus to select "Default" or "Open".
 Default: after the oscilloscope is powered on, you need to press the power key
on the front panel to start up the oscilloscope.
 Open: after the oscilloscope is powered on, it starts up directly. Note: At this
point, you can still press the power key on the front panel to turn off the
oscilloscope.
External Trigger Impedance
Users can set the input impedance of the [EXT TRIG] connector on the front panel.
Press UTIL  Extimpedance to select "1 MΩ" (default) or "50 Ω".
Aux Output
Users can set the signal type output from the [Trig Out/Calibration] connector on
the rear panel.
Press UTIL  AuxOutput to select the desired output type.
1. TrigOut
After this type is selected, the oscilloscope output a signal that can reflect the
current capture rate of the oscilloscope at each trigger.

Rigol DS6104 Specifications

General

Brand	Rigol
Model	DS6104
Category	Test Equipment
Language	English