Rigol DS6104 User Manual

RIGOL 14 Remote Control
14-8 DS6000 User’s Guide
Remote Control via GPIB
1. Connect the device
Use the USB to GPIB interface converter to extend a GPIB interface for the
oscilloscope. Then connect the oscilloscope to your PC using a GPIB cable.
2. Install the driver of GPIB card
Install the driver of the GPIB card which has been connected to the PC correctly.
3. Set the GPIB address
Set the GPIB address of the oscilloscope according to the description in "To Set
the GPIB Address".
4. Search device resource
Start up Ultra Sigma and click
to open the panel as shown in the
figure below. Click
and the software will automatically search for
the instrument resource currently connected to the PC through the GPIB
interface. The name of the device resource found will be displayed on the right
side of the panel. Click
to add the resource. Note that if you want to
remove the unwanted resource, click the resource name to select it and then
click
.
If resource cannot be found automatically:
 Select the GPIB card address of the PC from the dropdown box of "GPIB::"
and select the GPIB address set in the oscilloscope from the dropdown box
of "::INSTR".
 Click
to check whether the GPIB communication works

Rigol DS6104 Specifications

General

Brand	Rigol
Model	DS6104
Category	Test Equipment
Language	English