Rigol DS6104 User Manual

RIGOL 5 To Trigger the Oscilloscope
5-14 DS6000 User’s Guide
gValueTimeSettin
LowLevelUpLevel
SlewRate
−
=
imitTimeLowerL
LowLevelUpLevel
~
imitTimeUpperL
LowLevelUpLevel
SlewRate
−−
=
The adjustment mode of the trigger level is different when different vertical window
is selected:

: only adjust the upper limit of the trigger level. During the adjustment,
the "UP Level" and the "Slew Rate" change accordingly but the "Low Level"
remains unchanged.

: only adjust the lower limit of the trigger level. During the adjustment, the
"Low Level" and the "Slew Rate" change accordingly but the "UP Level" remains
unchanged.

: adjust the upper and lower limits of the trigger level at the same time.
During the adjustment, the "UP Level" and the "Low Level" change accordingly
but the "Slew Rate" remains unchanged.
Note: If you select "Slope" under the Type menu, you can press down Trigger
LEVEL continuously to switch over the options under the Vertical menu.
Trigger Mode:
Press Sweep to select the Trigger Mode (page 5-3) under this trigger type as auto,
normal or single. The corresponding status light of the current trigger mode turns on.
Trigger Setting:
Press Setting to set the trigger parameters (trigger holdoff) under this trigger type.

Rigol DS6104 Specifications

General

Brand	Rigol
Model	DS6104
Category	Test Equipment
Language	English