Rigol DS6104 User Manual

RIGOL 6 To Make Measurements
6-10 DS6000 User’s Guide
Press MATH  Operate to select "Logic":
 Press Formula to select the desired operation formula and the default is AND.
 Press Source A and Source B to select the desired channels. The channels
available are CH1, CH2, CH3 and CH4.
 Press Invert to turn the invert display of the operation results on or off.
 VERTICAL POSITION, VERTICAL SCALE, HORIZONTAL
POSITION and HORIZONTAL SCALE can also be used to adjust the
display of the operation results.
 Press Threshold A and use to set the threshold of source A in logic
operation.
 Press Threshold B and use to set the threshold of source B in logic
operation.
 Press Label to turn on the label modifying interface. You can refer to the
introduction in "
Channel Label" to set the label of the math operation
waveform. Note: The new label can include uppercase English letters (A to Z),
lowercase English letters (a to z), numbers (0 to 9), underlines and spaces and
the length cannot exceed 4 characters.

Rigol DS6104 Specifications

General

Brand	Rigol
Model	DS6104
Category	Test Equipment
Language	English