RIGOL 10 Waveform Recording
10-6 DS6000 User’s Guide
end frame settings. During the setting process, the screen will display the
corresponding waveform of the current frame synchronously, namely manual
playback.
If you perform the playback operation after setting this parameter, this menu will
be adjusted to the value corresponding to the "Start Frame" automatically and
will change continuously during the playback process.
5. End Frame
Press this softkey and use
to set the end frame of the playback. The default
is the number of frames of the waveform to be played back.
6. Playback Operation
Waveform playback can be realized through the shortcut buttons in the menu or
on the front panel.
Menu Front Panel
Press Operate and select " "
to start playing back.
Press to start the playback. The
backlight was illuminated yellow and starts
to blink.
Press
and select " "
to pause the playback.
Press
again to pause the playback. The
backlight was illuminated yellow
continuously and stops blinking.
Press
and select "â– "
to stop the playback.
Press to stop the playback. The
backlight was illuminated orange.
In waveform playback, use Run/Stop to switch between play and pause. Each
time Single is pressed, the Current Frame moves one frame forward.
To Next Page
Loading...
Need help?
General
