Rockwell Automation Publication 1766-UM001O-EN-P - September 2021 225
Appendix F MicroLogix 1400 Distributed Network Protocol
DNP3 Counter Object
The supported object group and variations are listed in this section. The
controller responds with the default group and variation when the DNP3
Master requests to read an object with Any variation.
Counter Static Objects:
• g20v0 – Counter – Any Variation
• g20v1 – Counter – 32-bit with flag
• g20v2 – Counter – 16-bit with flag
• g20v5 – Counter – 32-bit without flag (default)
• g20v6 – Counter – 16-bit without flag (default)
Counter Event Objects:
• g22v0 – Counter Event – Any Variation
• g22v1 – Counter Event – 32-bit with flag (default)
• g22v2 – Counter Event – 16-bit with flag (default)
Related Object File Number:
• 16-bit Counter Object File Number
• 32-bit Counter Object File Number
Related Configuration File Number:
• 16-bit Counter Config File Number
• 32-bit Counter Config File Number
To generate a Counter Object from the DNP3 Subsystem in the controller, you
should configure Counter Object File Numbers in the DNP3 Slave Application
Layer Configuration file.
When only one Counter Object File is configured, the Index number starts
from 0 for the configured object. One word is used for one Index of a 16-bit
Counter Object and one double word is used for one Index of a 32-bit Counter
Object.
If both the 16-bit Counter Object File Number and 32-bit Counter Object File
Number were configured in the DNP3 Slave Application Layer Configuration
file, the starting index number of 16-bit Counter Object is 0 and the starting
index number of 32-bit Counter Object starts from the ending index number of
the 16-bit Counter Object. For example, if 10 elements of a 16-bit Counter
Object were configured and 10 elements of a 32-bit Counter Object were
configured, the index number is:
• 16-bit Counter Object: From 0…9
• 32-bit Counter Object: From 10…19
To Next Page
Loading...
Need help?
General
