Sega Let's Go Jungle User Manual

74
CONTROL UNIT
11
● Afterthevolumehasbeenreplaced,besuretosetthevolumevalueonthetest
modecalibrationscreenandtheinputtestscreenandcheckvariationsinthe
volumevalue.
● Afteradjustingorreplacingamicroswitch,alwayscheckON/OFFoftheswitch
ontheinputtestscreenofthetestmode.
● HandlepartsinsidetheControlUnitverycarefully.Beespeciallycarefultoavoid
damage,deformationorlossoftheseparts.Ifanyoneofthesepartsislostor
defective,itcanresultindamagesand/orfaultyoperations.
CONTROL UNIT 11
● Whenworkingwiththeproduct,besuretoturnthepoweroff.Workingwiththe
poweronmaycauseanelectricshockorshortcircuit.
● Becarefulnottodamagethewires.Damagedwiresmaycauseanelectric
shock,shortcircuitorpresentariskofre.
● Donottouchanypartsthatarenotspeciedinthesedirections.Touchingun-
specied
locationsmayleadtoelectricshockorcauseshortcircuits.
● Thisworkshouldbeperformedbysitemaintenancepersonnelorotherskilled
professionals.Workperformedbynon-technicalpersonnelcancauseasevere
accidentsuchasanelectricshock.
● Exerciseduecautioninperformingsolderingprocedures.Ifsolderingironis
handledcarelessly,therecouldberesorburns.
● Proceedverycarefullywhenheatingthermalcontractiontube.Carelessop-
erations
canresultinresorburns.
● Whenfasteningplasticparts,becarefulnottotightenscrewsandnutsexces-
sively.Otherwisepartsmaybedamaged,resultingininjuriesfromfragments,etc.
● Becarefulnottogethandorngercaughtwhenremovingorattachingtheparts.
● Disconnectionandconnectionofconnectorswillbeperformedwithinthenar-
row
cabinetspace.Takeduecarenottoscratchorotherwiseinjureyourself.
● TakecarewhencarryingtheremovedControlUnits.Suchheavyliftingcarriesa
riskofinjurytobackorshoulders.
If the operability of the Control Unit is unsatisfactory, or if settings on the test mode calibration screen are ineffec-
tive, the problem could be a defective mechanism, displacement of the position where volume or microswitch has
been fastened, or malfunctioning of volume or microswitch.
Carry out the following procedure to replace Control Unit or microswitch. Also be sure to grease the mechanical
components of the Control Unit once every 3 months.

Sega Let's Go Jungle Specifications

General

Brand	Sega
Model	Let's Go Jungle
Category	Video Game
Language	English