SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 03/2018, C79000-G8976-C386-06
109
Programming via SIMATIC controller
This section is intended only for S7 users (RF680R/RF685R).
This section describes the programming and configuration of the RF680R and RF685R
readers via a SIMATIC controller. With the described functions, you can read out and write
transponder data via the readers.
Note
Programming and configuring the readers using STEP 7 for PROFIBUS operation
You will find information on programming and configuring the communications module you
are using for PROFIBUS operation in the manual of the relevant communications module.
To be able to configure Ident systems using STEP 7 Basic/Professional, you require suitable
Ident instructions. The Ident library with the Ident profile and the Ident blocks are integrated
in STEP 7 as of version V13 SP1.
To Next Page
Loading...
Need help?
General