Programming via SIMATIC controller
8.6 Programming the Ident profile
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 03/2018, C79000-G8976-C386-06
137
Programming the Ident profile
8.6.1
Structure of the Ident profile
Note
Parallel operation using Ident blocks and Ident profile is not possible
Note that the reader cannot be
operated at the same time using the Ident blocks and the
The blocks described in the section"Programming Ident blocks (Page 119)" represent a
simplified interface of the Ident profile. If the functionality available with the blocks is not
adequate for your application, you can use the Ident profile as an alternative. Using the Ident
profile, you can set complex command structures and work with command repetition. The
following graphic shows the Ident profile including the commands that can be implemented
with it.
Note
Ident profile for trained users
The Ident profile is a complex block containing all the functionality of the Ident blocks. The
Ident profile was developed specially for trained block users who want to configure complex
functions with their own blocks. For untrained users, we recomm
end using the Ident blocks.
To Next Page
Loading...
Need help?
General