36
To face the camera toward the front
(move to home position)
Press and hold the button on the joystick.
If you accidentally move the camera
head with your hand
If you move the camera head with your hand, or
your hand or other object in the vicinity of the
camera bumps the camera during pan/tilt
movement, the camera pan/tilt movement may
be incorrect. If this occurs, the STANDBY lamp
(POWER lamp on the ILME-FR7) and NETWORK
lamp of the camera blink to indicate incorrect
operation.
In this case, press and hold the CAM GUI / P/T
R
ST (pan/tilt reset) button to reset the pan/tilt
position.
If the camera moves in a different
direction than the joystick
By default, the camera pans to the right
whenever the joystick is inclined to the right. If
you want the camera to face toward the opposite
direction, for example, when changing the
direction of the camera while checking the
picture on a screen, you can change the direction
the camera moves using CONFIG >DIRECTION in
the RM menu.
For details about configuration, see “DIRECTION”
(page 74).
Note
The setting above only changes the control
signal from the unit, and does not change the
setting of the camera itself.
Zoom control
The camera zoom can be operated using either
the ZOOM ring on the top of the joystick or the
ZOOM lever in the lens control block.
You can set which is used to control the zoom
u
sing CONFIG >RM SETUP >ZOOM in the RM
menu.
For details about configuration, see “RM SETUP”
(page 73).
You can adjust the zoom speed using the ZOOM
S
PEED knob on the lens control block.
To control the zoom using the ZOOM ring
on the top of the joystick
NETWORK lamp blinks.
STANDBY
lamp blinks.
POWER lamp blinks.
Joystick Movement
of the
camera
CONFIG >DIRECTION
setting
Pan operation: Set
JOYSTICK PAN to
STANDARD.
Tilt operation: Set JOYSTICK
TI
LT to STANDARD.
Pan operation: Set
JOYSTICK PAN to REVERSE.
Tilt operation: Set JOYSTICK
TI
LT to REVERSE.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
